Kiddy World plus User Manual download pdf (Page 14)

• Slide locking clip onto vehicle seat belts

approximately 1/2 inch (1 cm) away from latch plate

(Fig. 8).

• Re-buckle vehicle seat belt.

- Check to be sure vehicle lap belt is still correctly

routed throughout entire belt path.

- Check to see that the protection shield is snuggly

adjusted onto child.

- If not snuggly adjusted, readjusting the vehicle seat

belt tightening is required.

- Unbuckle vehicle seat belt.

- Hold vehicle seat belts together and remove locking

clip.

- Readjust the lap belt.

- Re-attach locking clip.

- Buckle vehicle seat belt.

- Test installation to see if protection shield is snuggly

adjusted, if not snugly adjusted, repeat above steps

until protection shield is snugly adjusted.

• Check that the protection shield is snuggly adjusted

onto the child’s torso each time the child is secured

into the Todder car Seat.

4.4 Vehicle seat back and headrest adjustment

- Place the car seat on the vehicle seat,

center the car seat in the seating position

so that car seat back contacts the vehicle

seat back.

- The backrest of your car seat should sit

right up against the vehicle’s seat back.

- If the vehicle headrest holds the car seat

forward of the vehicle seat back, the

headrest should be removed (car seat

forward of vehicle seat back) (Fig. 9).

Fig. 8

Fig. 9

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 43 44

No comments

Kiddy World plus User Manual Page 14