Kiddy World plus User Manual download pdf (Page 27)

When snuggly adjusted, the vehicle seat belt should not allow any slack. The

vehicle belt should lie in a relatively straight line and be flat, without sagging

or twist. The protection shield should contact the child but not press on the

child's flesh or push the child's body into an unnatural position.

NOTE: The protection shield must rest firmly on your child's tummy.

Next, thread the vehicle's shoulder belt

completely into the red belt guide on both

sides of the protection shield (yellow arrows

in Fig. 36).

NOTE: Make sure that all belts lie flat and

are not twisted over each other.

If the shoulder belt has a switchable

retractor, switch the retractor into the

locking mode.

If the lap and shoulder belt has a free sliding latch plate and an ELR, a

locking clip is required to secure the lap belt snuggly around the car seat.

See “Locking Clip Installation and use” section (P. 12).

Tighten the vehicle shoulder belt again by

pulling in direction of the shoulder belt

retractor (Fig. 37).

Check that the protection shield is snuggly

and properly adjusted (Fig. 37).

Make sure that the vehicle belts are snuggly

adjusted and not twisted.

The protection shield is contacting your

child and that there is no gap between the

protection shield and child's torso.

NOTE: If vehicle lap and shoulder belt does not stay snugly adjusted around

the protection shield and child a locking clip (or belt lock-off) may be

required (see Locking Clip Installation and use” section (P. 12)).

Fig. 36

Fig. 37

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 43 44

No comments

Kiddy World plus User Manual Page 27